67 GHz Physical Layer Test System
Agilent N1930 Series
Physical Layer Test Systems
The Physical Layer Test System (PLTS) consists of the following items:
• Personal computer (PC)
• VNA-based system (Network analyzer and S-parameter test set)
• PLTS software
The installation procedure in this chapter will lead you through setting up the hardware (the
PC and the VNA-based system). After that is complete, you will refer to Chapter 3, Installing
the PLTS Software, to install the software.
NOTE If you have the TDR-based PLTS system, refer to Chapter 2, “Installing the
TDR-Based Physical Layer Test System Hardware,” on page 31 for instructions
on setting up that system.
This installation procedure will lead you through a series of steps to set up your PLTS
hardware. The following is a list of the installation steps:
• Step 1. Set Up the Personal Computer
• Step 2. Verify your System Shipment
• Step 3. Set Up the Network Analyzer
• Step 4. Attach the Test Set to the Network Analyzer (N4420B or N4464A/B Test Set Only)
• Step 5. Install the S-Parameter Test Set on a Bench Top or in an Equipment Rack
• Step 6. Make the Interconnections between the S-Parameter Test Set and the Network
Analyzer
• Step 7. Set Up the General Purpose Interface Bus (GPIB)
• Step 8. Power up the Physical Layer Test System
Bookmark:Digg Del.icio.us Reddit
